Discussion about this post

User's avatar
Kelly's avatar

I will never forget getting to my MRI appointment, looking at the tube, realizing I would never fit, and them saying, just try it you will definitely fit... Cut to a few minutes later, they are moving the table into the tube and I can feel the tube physically pressing in on my from all sides, squeezing me…. I was screaming for them to let me out… it was really horrifying!

Only then did they agree to let me reschedule in the open MRI machine, but not until after putting me through a horrifying, embarrassing painful experience.

Expand full comment
Cathy's avatar

I am a fat person and an MRI technologist (Radiographer) in the UK. While I agree completely that there should be access to MRI for everyone and I passionately believe that fat people should not be shamed or blamed when MRI is unavailable to them, there seems to be a lot of misunderstanding about the design and process of the scan so I would like to clarify a few things.

1. The design of the machine boils down to the physics of creating an MRI image. This is a very complex process and the width of the bore is key for the process to work. Wide bore scanners are now pretty standard (here at least) when new scanners go in, but many facilities can’t afford to spend another million+ on a new scanner, so the ones in place are likely to remain for some time. In my experience a scanner can stay in place for up to 20 years. I disagree with the comments that the original design is fatphobic - it’s just the only way an image could be obtained at that time. All imaging modalities have advantages and disadvantages. There are people who cannot have an MRI because it’s unsafe for them to do so, for example because they have a pacemaker - it’s not discriminatory, it’s just not compatible because of the way the scanner works.

2. The “fixtures” are not a thing to keep people still. They are coils, which allow signal to be collected and turned into an image via a lot of complex maths. You can’t get the image without the coil. Again, yes there are limitations, and a good MRI tech will know how to get a diagnostic image using a different piece of equipment if the one that should be used does not fit over the patient’s body part, but it will be very difficult to get an image that is as good as it should be in the same time. Often it will take longer and some of the image quality will be lost.

3. There is more to acquiring a diagnostic image than just fitting the patient in the scanner/coil. Signal (that creates the image) is affected by proximity to the coil, so for example a patient’s spine can be nearer or further away from the spine coil (which they are lying on top of) depending on the depth of tissue between their spine and their skin. So for people carrying a lot of fat on their back, the spine image will not be as clear, unless the tech takes steps to improve this, which usually adds time to the examination. That’s just an example, there are other issues.

4. I have worked in MRI for 12 years and I put people into our wide bore scanner every day, and I still can’t tell from their weight/height/measurements whether they will fit in or not, or whether they will tolerate the scan. I have scanned patients up to 190kg (over 400lbs) in a wide bore scanner (table limit 250kg) and if a patient were willing to try, I would not exclude them based on their measurements. That is why techs will usually ask patients to try. It is always the patient’s choice and consent can be taken away at any time. It is undoubtedly much more difficult for a bigger person than it is for a smaller one in lots of ways and your clinician should understand that.

5. There are other imaging modalities where the size of a patient impacts on the quality of the image, for example X-rays and CT scans. Sometimes it’s not possible to obtain a diagnostic image even though it seems that it has been no different to the process any patient would go through. You need a higher dose of radiation and the resultant X-ray may not be as good. Again it’s the limitations of the modality which is down to physics. It’s not the patient’s fault, but it’s not the technologist’s fault either.

I hope this is helpful in understanding a bit more about the MRI examination. It is a very complex process. I am sorry to hear of the bad experiences people have talked about in the comments. I can’t comment on open scanners as I’ve never worked on one, so I’m just speaking from my own experience. I think the main issue is that all healthcare professionals should be treating higher-weight patients with respect and compassion and that is what I will strive to do and help others to do in my work.

Expand full comment
9 more comments...

No posts